 |
Mechanical data
Pull and Push force
1000N and nominal force of 150N
Carriage travel
Ca. 120mm/sec with soft start and soft stop
Opening time garage door
Approximately 18 sec.
Speed control
Electronic controlled, adjustable open and closing speed
Adjustable soft stop and soft start; 200mm, 300mm, 400mm or off
For use with
Garage doors up to 6 m. wide with maximum weight of 200Kg.
Maximum parking facility of 24 cars with 48 daily open & close cycles
Electrical data
Connected load
230 Volt, 50 Hz. 0,20 KW, 0.7A
Energy saving circuit
Total consumption of non-activated garage door operator is ca. 3,9W.
Operating mode
Short period operation max. KB 2 min per 10 min. for 700N motor
Short period operation max. KB 5 min per 10 min. for 1000N motor
Control unit voltage
Low voltage ca. 24 Volt
Output power for accessories: 24 VDC, 50 mA max., short circuit protected
Garage light
Automatic shut off after ca. 180 seconds (adjustable 90 - 240 seconds)
1 Î 40 W max., E14 light bulb (not included)
Protection category
Only suitable for inside dry buildings. IP20 protection, category II
Motor and transformer
Direct Current worm gear motor,
Mains regular current transformer with Thermal overload protection
Control unit
Microprocessor controlled
Three board principle
Personal Computer diagnostics with special software is possible
Functional data
Adjustment
Simple and easy 3 step programming: open limit position, close limit position and learn transmitter code. All other parameters can be set with step by step numerical menus.
Display
Unique numerical display
Safety & features
Automatic cut out
Electronic force control by motor current control
Integrated self learning force control with adjustable offset
Individual open and close force setting in program menu
Automatic full door reverse when detected obstruction under closing door |
Excess travel stop
Security cut-out after 80 sec. travel time (adjustable 30 - 240 sec)
Block protection
Additional to automatic cut out, by microprocessor and RPM sensor
Back-drive guard
Electronic back-drive prevention by permanent protection of door closed position (automatic close after ca. 1 cm. detected reversed motor movement)
Travel cut out
Electronic travel cut out by reference point processing
Warning light output
Integrated signal light connection output for external relay (not included)
Warning time: 0 - 70 sec
Automatic closing function
Integrated with adjustable warning and door open time
Door open time: 5-255 sec.
Intermediate door position
A fixed half door open position can be programmed (only with the radio models)
Digital radio system
(optional for “NR” models)
Transmitter with code learning function and Multibit technology
External plug in receiver integrated. Self learning and Multibit-coding
Frequency 868 MHz. or 433 MHz.
Reset function
All programmed functions will be reset to factory setting
Remote diagnostics
Easy malfunction indication on numerical display. Assigned error number per possible malfunction
General data
Housing
Motor cover in shock resistant ABS. 2-screw fastening
Snap-on/off lens cover (no screws)
Snap-on/off cover for wire terminal access; not required to remove motor cover to access wire connections.
Rails and carriage
1-piece or 2-piece split C-channel pre-assembled rails
Chain, toothed cable or belt system
Durable anti-wear synthetic carriage with emergency release cord with automatic engage system.
Installation parts (fittings)
Standard installation kit without screws for lintel and ceiling
Includes: Z-style door arm, two mounting straps, two rail clamps and hardware for door bracket installation on steel doors
Packaging
Individual packaging for motor head and rail
Weight motor head completely packaged: 5,50 Kg
Other
Owners & Installation manual in local language(s)
Ca. 1 meter long power cord
     |
