|
|
|
|
home l product overview l contact us l downloads | |
|
|
|
| Technical specifications | Base
model
O KS0.230V-868MHz. II or KS0.230V-NR II (without radio system) |
|
 |
Carriage travel Ca. 0,14 m/sec with soft start and soft stop Pull and Push force 550N.
Garage light Automatic shut off after ca. 180 seconds 1 x 40 W max., E14 light bulb (not included) Connected load 230 Volt,
0,20 KW Energy saving circuit Total consumption of non-activated garage door operator is ca. 0,0039 KW. Operating mode Short period operation max. KB 2 min Motor and transformer Direct Current worm gear motor, Mains regular current transformer with Thermal overload protection Control unit Microprocessor controlled, All-on-one circuit board principle, Personal Computer diagnostics with special software is possible Control unit voltage Low voltage ca. 24 Volt, Output power for accessories: about 24 VDC, 50 mA max., short circuit protected Protection category Only suitable for inside dry buildings (IP20) Adjustment Simple and easy 3 step programming: open limit position, close limit position and learn transmitter code. All other parameters can be set with step by step menu; Optical sensor presence, independent open and close force control. Automatic cut out Electronic force control by motor current control, Integrated self learning force control with adjustable offset, Individual open and close force setting in program menu, Automatic full door reverse when detected obstruction under closing door Packaging |
Display Operator status or diagnostics displayed by 4 light diodes Excess travel stop Security cutout after 80 sec. travel time Block protection Additional to automatic cut out, by microprocessor and RPM sensor Back-drive guard Electronic back-drive prevention by permanent protection of door closed position (automatic close after ca. 1 cm. reversed movement) Travel cut out Electronic travel cut out by reference point processing Speed control Electronic controlled soft stop and soft start Digital radio system (possible) Transmitter with code learning function and Multibit technology, Receiver integrated on motor control board. Self learning Multibit-coding Frequency 868 or 433 MHz. Housing Motor cover in shock resistant ABS. 3-screw fastening, Snap-on/off lens cover (no screws), Snap-on/off cover for wire terminal access; not required to remove motor cover to access wire connections. Rails and carriage 1-piece or 2-piece split C-channel pre-assembled rails, Chain or belt system, Durable anti-wear synthetic carriage with emergency release cord with automatic engage system Installation parts (fittings) Standard installation kit without screws for lintel and ceiling, Includes: Z-style door arm, two mounting straps, extra rail/ceiling support and screws for door bracket installation on steel doors All our products are CE certified.      |
|
|
|
|
|
|